Lake In the Hills, IL
KBI Plumbing

Do you have a clogged Drain line? Kbi Plumbing can clear any obstructions with our "Rodding" services. Whether it's "Kitchen Lines, Bathroom Lines, or any other Lines we have the tools and experience to remove debris, tree roots, grease, mud, and much much more.

Sewer Pipe Buzzwords

Sewer Cleaning | Rodding Deals

Near Lake In the Hills, IL


Sewer Line

Power Rodding

$ $129
One time payment


Sewer Line

Power Rodding

$ $89
One time payment


Hydro Jetting

Starting at

$ $385
One time payment

Signs You May Need You're Drain Lines Cleaned Lake In the Hills, IL

  • Drains Clog Frequently
  • Tree's Have Grown Around Or Near Your Sewer Lines
  • There's A Large Obstruction In Your Lines
  • You've Experienced an Increase In Your Water Bill
Seepage Tiles

Older Homes And Why They Need Frequent Drain Line CleanOuts | Lake In the Hills, IL

Homes built prior to the 1980s tend to be more susceptible to drain clogging issues.
            To minimize blockages and clogs it's a good idea to annually have the drain lines cleaned.

            A simple, effective and affordable method of cleaning would be through
            Drain & Sewer Rodding, aka  Power Rodding. Power Rodding is a method of clearing Sewer & Drain Lines & Pipes through the use of rotating blades that chop through the clogging debris

BEWARE of Plumbers that guarantee they can | Lake In the Hills, IL

What Drain & Sewer Services CAN NOT Guarantee

Grease blockages occur in waste or sanitary Pipes. Grease typically enters the Pipe from the kitchen sink, dishwasher and garbage disposal. Pipes packed with grease need to be Sewer rodded out. Calculating the volume of Grease in a Pipe is impossible. Since the amount is unknown Sewer rodding clears the Pipe blockage the job is assumed to be complete. If by chance the drain Pipe is filled with grease, the grease will droop, closing the recently cleared path that the Sewer Rodder cleared, clogging the Sewer Pipe again. Upon this occurrence, additional steps are required in order to open the Sewer Pipe. Grease receptors, periodic roddings and water jet rodding, chemicals specially designed for grease can help with preventative maintenance, and contribute to an overall reduction of grease and oil products that enter the Sewer Pipes.

When running the disposal, always run cold water before and at least wait two minutes after grinding from the garbage disposal is completed before moving on to wash the food waste down the drain Pipe. Grounding up food in small batches, allows the food to wash down the drain Pipe, this helps prevent the disposal and drain Pipe from becoming clogged up. Avoid grinding up these foods: Corn Husks, Corn Cobs; Onion Peel; Artichoke Leaves, Banana peels, Celery, or any other fibrous foods.

Mud can enter Sewer Pipe s from driveway or area drains and yard waste can enter drain Pipes from dirty gutter Pipes.
Because neither mud nor organic matter will break down into a liquid form like sewage, this matter tends to accumulate and create stoppages. The only way to prevent these types of stoppages is to keep driveway drains and gutters clean, and perform preventative rodding maintenance on those Pipes.

Many people do not realize that sanitary Sewer Pipes are ONLY designed to accept human waste or toilet paper. Anything else flushed down the Pipe, can cause blockages.

A blockage caused by broken or collapsed Pipes usually occurs with age and is normally caused by interaction with tree roots, heaving and settling of the earth or settling of the building. A broken or sheared Sewer Pipe is usually found by pulling mud back on the end of the rod or an inability of the rod to go any further into the Sewer Pipe. Once a Sewer Pipe has broken, the only remedy is to insert a Sewer camera into the Pipe to determine the true cause of the problem, the location of the problem and the condition of the Pipe up to the point of the problem. The decision to repair or replace the Sewer Pipe and the cost associated with the work cannot be determined without first inspecting the Sewer Pipe.

Small Sewer Pipes that have a 90' bend often times cause blockages. Many older types of waste fittings that were widely adopted in the past are commonly found to cause problems. These Sewer Waste Fittings are no longer used today and can be fixed by replacing the Sewer Pipes.

A broken Pipe will slowly accumulate waste matter flowing down the pipe until the SewerPipe stops up. Once we determine that a Sewer Pipe is broken, there is no way to determine how long the Pipe will remain open or how much time it will take before the broken Pipe worsens, making an immediate dig and repair necessary.

In the Midwest, our weather freezes the ground in the wintertime. The ground contains water. When water freezes it expands and heaves the ground upward. In the spring, the ground thaws and the earth settles again. The continuous freeze-thaw cycles can cause the ground surrounding a Sewer Pipe to heave causing a sag in the Pipe. If the Sewer Pipe already has a leak, allowing the surrounding ground to become saturated, the freeze-thaw cycle can have a more pronounced effect.

Sewer Pipes will sometimes sag. This happens when the ground underneath the Sewer settles or the ground heaves up due to frost. When the ground moves, the Sewer Pipe no longer has the standard, steady quarter inch drop per foot but will create a sag or belly that will trap waste and water. When waste becomes trapped in the sagging portion of the Sewer pipe, that waste will harden and slowly accumulate until a Pipe stoppage occurs. Normal Sewer rodding will usually remove the stoppage and clear the Sewer Pipe but this will only be a short lived temporary solution. Only a dig and replacement of the sagged Sewer Pipe can provide a longer lasting repair.

When city storm and sanitary Pipes are full or "charged," the drain Pipes that run from the home cannot drain. Additionally, the full city drain Pipes carry much more debris than the individual house Sewers. Sometimes when a city Sewer fills to the point where it starts to back up, water and debris flow up the Sewer Pipe toward the home. Once the city Sewer empties, that debris is left behind which can cause a Pipe stoppage. Depending upon how much water is backing up into a city Sewer main, that Sewer main can become full to the point where it backs up into and floods a home. There is nothing that can prevent the flooding once it starts. Once the city Sewer drains, the water left in the basement will usually drain away. There are a few ways to prevent a full city Sewer from flooding a basement, they include the installation of a standpipes or a backwater valve.

Less common are blockages caused by malfunctioning check valves or back flow preventors. Repair or replacement of these devices along with annual maintenance should help to eliminate problems.

Less common are blockages caused by malfunctioning check valves or back flow preventors. Repair or replacement of these devices along with annual maintenance should help to eliminate problems.

Sewer Pipe Preventative Maintenance Versus Repair Replacement | Lake In the Hills IL

Sewer Pipe Preventative Maintenance

There are many customers who are on preventative maintenance schedules with our company. The idea is to rod a Sewer Pipe with enough frequency to prevent the Sewer Pipe from backing up into the house. The frequency of rodding maintenance is historically based and differs with every Sewer Pipe. We have customers who know, from past experience, that they need to rod their Sewer anywhere from once every other year to up to 4 times a year.

Over time, a Sewer will require move frequent rodding maintenance because problems with a Sewer Pipe do not get better over time, they get worse. When a customer reaches the point where they require preventative rodding maintenance two or more times a year, we will usually suggest inspecting the Pipe with our Sewer camera to determine the type of problem and a cost for a long lasting solution.

At this point the customer has to decide how much longer they intend on living in the house and calculate the maintenance cost versus the repair. Other considerations should include the risk of damage when a Sewer does backup (if not repaired) and the value of the home when selling due to a problematic Sewer, (Disclosure laws prevent homeowners from not informing prospective buyers of the Sewer history.

Sewer Pipe Repair, Replacement, And Excavation

If preventative Sewer rodding isn't regularly maintained, roots can overgrow the Sewer Pipe allowing debris to accumulate past the point where Sewer Rodding can no longer be performed.

If Sewer rodding takes longer than 3 hours and debris is still being removed odds are if Sewer rodding continues time is being wasted rodding when it should be used excavating. With our equipment 3 hours indicates a large blockage.

When we rod a Sewer Pipe and we hit an obstruction, we remove our cables and re-try the rodding process two or three times more before considering excavation for a solution.

If the Sewer rodding cables get pulled out of the Sewer for inspection, and clay is found on the cutting head, this is a clear indication that the Sewer Pipe is broken and excavation is the proper step for repair.

Not all Sewer Pipes can be Sewer rodded to clear. When a Sewer Pipe has an irregularly large root infestation, collapses, or shears; Excavation becomes the only solution and the Sewer Pipe will require replacement of a portion or the entire Sewer Pipe.

Need Some Plumbing Assistance?

Upon Filling Out This Form We Will Promptly Reach Out To You.

Local Reviews
for Lake In the Hills, IL

Mobile Tools for Contractors and Service Professionals Reviews powered by Nearby Now